Network Sync: Ableton Live to MainStage
Let Ableton Live set the tempo while StagePhrase plays your parts in MainStage.
What the connection does
Network Sender shares Live’s tempo, beat and bar position, time signature and transport with StagePhrase. It carries timing only. Load and trigger your phrases in StagePhrase as usual. Your Ableton arrangement, locators and sections stay in Live.
Requirements
You need StagePhrase in MainStage and Network Sender in Live. Keep both hosts processing audio. If you use two Macs, connect them to the same local network. A wired connection is a good starting point for a live rig.
Walkthrough: Ableton Live → Network Sender → MainStage
- In MainStage, open StagePhrase and check that your phrases can play through their audio or MIDI outputs. Set Tempo Source to Network Sync.
- In Ableton Live, add StagePhrase Network Sender as a VST3 audio effect on an active track, such as Main.
- In Sender, pick the receiver under Destination. For both hosts on one Mac, choose Manual, enter 127.0.0.1 under Receiver and set Port to 45091. For two Macs, enter the address of the Mac running MainStage and use the same port.
- Turn Send on and start Live. Check for SYNCED in Sender and NETWORK / CONNECTED in StagePhrase. The two BPM displays should agree.
- Trigger a phrase in StagePhrase with a beat or bar value in Quantize Start. Listen to how it comes in against Live. Save both projects once the setup works.
Audio and MIDI during tempo changes
MIDI follows the tempo received from Live. If a recording also needs to speed up or slow down during the song, enter its original Source BPM and choose Follow Tempo. Try a tempo change before the show and listen to both parts. Follow Tempo makes Catch-Up and Late Start unavailable.
Loss of connection and recovery
If timing is lost, StagePhrase stops playback and releases held MIDI notes. Wait for CONNECTED, then trigger your parts again when you’re ready.
If it does not connect
For WAITING or DISCONNECTED, check Send, the receiver address and whether both hosts are processing. If discovery does not list your receiver, try Manual and check local-network permissions.
If you see PORT UNAVAILABLE, another receiving host or process may already be using port 45091. Close the extra receiver and reconnect. If the status is CONNECTED but the phrase is silent, check the phrase’s output and try PLAY.
StagePhrase Network Sender →Troubleshooting StagePhrase 2.0 →